Display Isdn Spid - H3C MSR810 Command Reference Manual

T310
T313
T322
Table 28 Command output
Field
T200(sec)
T201(sec)
T202(sec)
T203(sec)
N200
K(BRI)
K(PRI)

display isdn spid

Use display isdn spid to display SPID information for NI-enabled BRI interfaces.
Syntax
display isdn spid [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies a BRI interface that runs the NI protocol. If you
do not specify an i nterface, the command displays SPID information for all NI-enabled BRI
interfaces.
Examples
# Display SPID information for NI-enabled interface BRI 2/4/0 (the SPID type is AUTO).
<Sysname> display isdn spid interface bri 2/4/0
Interface Bri2/4/0:
SPID Type: AUTO
SPID B1:
SPID Num: 235
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
SPID B2:
130
6
8
Description
Q.921 T200 timer sets the retransmission interval (in seconds).
Q.921 T201 timer sets the minimum interval (in seconds) between the
retransmissions of a TEI Identity check message.
Q.921 T202 timer sets the minimum interval (in seconds) between
transmissions of TEI Identity request messages.
Q.921 T203 timer sets the maximum amount of time that the data link can
be idle.
Q.921 N200 counter sets the maximum number of retransmissions.
Maximum number of unacknowledged frames (sliding window size) on the
ISDN BRI interface.
Maximum number of unacknowledged frames (sliding window size) on the
ISDN PRI interface.
161