Display Diagnostic-Information - H3C s3100 series Command Manual

Description
Use the debugging command to enable system debugging.
Use the undo debugging command to disable system debugging.
By default, all debugging is disabled for the system.
Note that:
Enabled debugging will generate a great deal of debugging information and thus will affect the
efficiency of the system. Therefore, it is recommended not to enable debugging for multiple
functions at the same time. To disable all debugging at a time, you can use the undo debugging
all command.
The specific debugging information can be displayed on a terminal only after you have configured
the debugging, terminal debugging, and terminal monitor commands.
To display the enabled debugging types, use the display debugging command.
For information about the terminal monitor command, refer to Information Center Command.
Example
# Enable IP packet debugging of the IP module.
<Sysname> debugging ip packet
<Sysname> display debugging
IP packet debugging is on

display diagnostic-information

Syntax
display diagnostic-information
View
Any view
Parameter
None
Description
Use the display diagnostic-information command to display system diagnostic information, or save
system diagnostic information to a file with the extension .diag in the Flash memory.
Example
# Save system diagnostic information to the file default.diag.
<Sysname> display diagnostic-information
This operation may take a few minutes, continue?[Y/N]y
Diagnostic-information is saved to Flash or displayed(Y=save N=display)?[Y/N]y
Please input the file name(*.diag)[flash:/default.diag]:
The file is already existing, overwrite it? [Y/N]y
% Output information to file: flash:/default.diag.
Please wait......
1-8