Configuring Flash Time - Auerswald COMpact 3000 analog Operating Manual

Settings
Analogue Connection

Configuring Flash Time

– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. In the Apply country settings from list field, select the desired country.
5. Click OK.
For the analogue port, the default settings for the country selected are configured
under General info, Line connection, Start of call (outgoing calls), End of the
call, CLIP, Control commands, Tones and Ring signal.
Further steps:
– Save your settings before you leave the page.
Configuring Flash Time
The flash time indicates how many milliseconds the PBX interrupts the voice circuit to trigger
special functions.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
374
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020