Show Snmp Trap Filter - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show snmp trap filter

Displays the current SNMP trap filter status.
show snmp trap filter
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
To display a list of traps and their ID numbers, use the
Examples
-> show snmp trap filter
ipAddress
-------------------------------------------------------------------------------
199.199.101.200 :
199.199.101.201 : no filter
199.199.105.202 :
199.199.101.203 :
199.199.101.204 : no filter
The following is an example of the output display with IPv6 information.
-> show snmp trap filter
ipAddress
-----------------------------------------+-----------------------------------
172.21.160.32
172.21.160.12
0300:0000:0000:0000:0211:d8ff:fe47:470b
0300:0000:0000:0000:0211:d8ff:fe47:470c
output definitions
IPAddress
TrapId List
page 61-28
: trapId list
0 1 2 3
0 1 2 3
15 16 17 18
20 22 30
IP address of the SNMP management station that recorded the traps.
Note: OmniSwitch stackable and chassis-based switches support both
IP and IPv6 SNMP stations.
Identification number for the traps being filtered.
show snmp trap config
4 5 6 7 8
19
trapId list
1 3 4
no filter
4 5 6
no filter
OmniSwitch CLI Reference Guide
SNMP Commands
command.
9 10 11 12 13 14
June 2012