SNMP Commands
show snmp trap config
Displays SNMP trap information. Information includes trap ID numbers, trap names, command families,
and absorption rate. This command also displays the Enabled/Disabled status of SNMP absorption and the
Traps to WebView service.
show snmp trap config
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
N/A
Examples
-> show snmp trap config
Absorption service : enabled
Traps to WebView : enabled
Id trapName
--+------------------------------------+---------------+------------
0 coldStart
1 warmStart
2 linkDown
3 linkUp
4 authenticationFailure
5 entConfigChange
30 slPesudoCAMStatusTrap
31 slbTrapException
32 slbTrapConfigChanged
33 slbTrapOperStatus
34 ifMauJabberTrap
35 sessionAuthenticationTrap
---------------------------------------------------------------------
output definitions
Id
Trap Name
Family
Absorption
OmniSwitch CLI Reference Guide
family
chassis
chassis
interface
interface
snmp
module
bridge
loadbalancing
loadbalancing
loadbalancing
interface
session
Identification number for the trap.
Name of the trap.
Family to which the trap belongs.
Time needed for the trap to process.
June 2012
absorption
15 seconds
15 seconds
15 seconds
15 seconds
15 seconds
15 seconds
15 seconds
15 seconds
15 seconds
15 seconds
15 seconds
15 seconds
page 61-31