Table of Contents
Advertisement
Viewing PoE Power Supply Status
Viewing PoE Power Supply Status
To view the current status of power supplies installed, use the
-> show power
Slot
PS
Wattage
----+----+---------+------+-----------+----------
1
1
900
1
2
900
For detailed information on the show power command output, refer to the OmniSwitch 6250/6450 CLI
Reference Guide.
Configuring Power over Ethernet Parameters
Power over Ethernet Defaults
The following table lists the defaults for PoE configuration:
Parameter Description
PoE operational status
Total power available to a port
Total PoE power available to an
entire chassis
Power priority level for a port
Priority disconnect status
Understanding and Modifying the Default Settings
The sections below provide information on each of the key components within the Power over Ethernet
software. They include information on PoE-related CLI commands. For detailed information on PoE-
related commands, refer to the OmniSwitch 6250/6450 CLI Reference Guide.
Note. PoE units support different wattage power supplies. If an unsupported power supply is used, a
console message and a trap are generated.
page 5-4
Type
Status
Location
AC
UP
Internal
AC
UP
External
Command(s)
lanpower start
or
lanpower power
lanpower maxpower
lanpower priority
lanpower priority-disconnect
OmniSwitch 6450 Hardware Users Guide
Managing Power over Ethernet (PoE)
show power
command, as shown below:
Default Value/Comments
lanpower stop
Disabled
Varies depending on chassis and
power supply type. For more
information, refer to product
specifications in Chapter 2.
Varies depending on chassis and
power supply type. For more
information, refer to product
specifications in Chapter 2.
Low
Enabled
January 2015
Advertisement
Table of Contents
