Show Vlan Router Mac Status - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show vlan router mac status

Displays current status of multiple MAC router mode, the number of VLANs configured on the switch, the
number of VLANs with router interfaces and the number of IP router interfaces configured.
show vlan router mac status
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Only single MAC router mode is supported at this tine, so multiple MAC router mode always displays
as disabled.
•
In single MAC router mode, a maximum of 4094 VLANs can have IP router interfaces defined. Note
that these limits are subject to the availability of switch resources.
Examples
-> show vlan router mac status
router-mac-multiple
----------------------+-------------+--------------+----------
disabled
output definitions
router-mac-multiple
total vlans
router vlans
ip vlans
Release History
Release 6.6.1; command was introduced.
page 22-18
total vlans router vlans
5
Multiple MAC router mode status: enabled or disabled. If this mode is
disabled, the switch is running in single MAC router mode.
The total number of VLANs configured on the switch. Use the
command to create or remove VLANs.
The total number of VLANs configured on the switch that have at least
one router interface defined (IP). Use the
define an IP router interface for a VLAN.
The total number of VLANs configured on the switch that have an IP
router interface defined. Use the
router for a VLAN.
OmniSwitch 6250 CLI Reference Guide
VLAN Management Commands
ip vlans
1 1
ip interface
ip interface command to define an IP
vlan
command to
November 2009