Enable Snmp Trap Updown - H3C MSR Series Command Reference Manual

Eth0/2
Eth0/3
Table 25 Command output
Field
Loadsharing Type
Port Status
Flags
Aggregation Interface
Aggregation Mode
System ID
Local
Port
Status
Priority
Oper-Key
Flag
Remote
Actor
Partner

enable snmp trap updown

Use enable snmp trap updown to enable linkUp/linkDown trap generation for the aggregate
interface.
Use undo enable snmp trap updown to disable linkUp/linkDown trap generation for the aggregate
interface.
Syntax
enable snmp trap updown
undo enable snmp trap updown
U 32768 1
U 63 1
Description
Load sharing type:
•
Shar—Load sharing.
•
NonS—Non-load sharing.
Port state: Selected or unselected.
LACP state flags:
•
A—LACP is enabled.
•
B—LACP short timeout.
•
C—The sending system detects that the link is aggregatable.
•
D—The sending system detects that the link is synchronized.
•
E—The sending system detects that the incoming frames are collected.
•
F—The sending system detects that the outgoing frames are distributed.
•
G—The sending system receives frames in default state.
•
H—The sending system receives frames in expired state.
Name of the aggregate interface.
Mode of the aggregation group:
•
Static for static aggregation.
•
Dynamic for dynamic aggregation.
Local system ID, containing the system LACP priority and the system MAC
address.
Information about the local end.
Port type and number.
Port state: selected or unselected.
Port aggregation priority.
Operational key.
LACP protocol state flag.
Information about the remote end.
Local port type and number.
Remote port index.
104