Avaya S8700 Maintenance Manual page 1229

DID-DS1 (Direct Inward Dial Trunk)
System Technician-Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order they are presented in the table below. By
clearing error codes associated with the NPE Crosstalk test, for example, you
may also clear errors generated from other tests in the testing sequence.
Order of Investigation
NPE Crosstalk test (#6)
Conference Circuit test (#7)
Port Audit and Update test (#36)
1. D = Destructive; ND = Nondestructive
NPE Crosstalk Test (#6)
The NPE Crosstalk test verifies that this port's NPE channel talks on the selected
time slot and never crosses over to time slots reserved for other connections. If
the NPE is not working correctly, 1-way and noisy connections may be observed.
This test is usually only part of a port's long test sequence and executes in about
20 to 30 seconds.
Table 8-205. Test #6 NPE Crosstalk Test
Error Test
Code Result Description / Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required for this test are not available.
The port may be busy with a valid call.
1. Use display port UUCSSpp to determine the trunk group/ member
2. If the port status is active but the port is idle (no calls), check the error log
3. If the port status is idle, retry the command at 1-minute intervals up to 5
1001 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
555-233-143
number of the port. Use the status trunk command to determine the
service state of the port. If the port is in use, wait until it is idle before
testing.
for Error Type #1025. The port may be locked up.
times.
Short Test Long Test
Sequence Sequence
X
X
X X
Continued on next page
Issue 1 May 2002
1
D/ND
ND
ND
ND
8-507