Avaya S8700 Maintenance Manual page 1464

Maintenance-Object Repair Procedures
Error Log Entries and Test to Clear Values
Table 8-289. EPN-SNTY Error Log Entries
Error
Type Aux Data
1
0 0
8801 (a) Any
8803 (b) Any
9901 (c) Any
9902 (d) Any
9903 (e) Any
9904 (f) Any
9905 (g) Any
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
Notes:
a. Error 8801 occurs whenever the PN is unable to send up-link control
messages and the control channel of the PN's TDM bus is swapped as part
of the recovery procedure.
b. Error 8803 occurs whenever the PN is unable to send up-link control
messages and the PN's Tone-Clock is swapped as part of the recovery
procedure.
c. Error 9901 occurs whenever the PN is unable to send up-link control
messages, but recovers after the control channels of the PN's TDM bus are
swapped.
d. Error 9902 occurs whenever the PN is unable to send up-link control
messages, but recovers after the PN's active Tone-Clock is swapped.
e. Error 9903 occurs whenever the PN is unable to send up-link control
messages, but recovers after a PNC interchange has taken place.
f. Error 9904 occurs whenever the PN is unable to send up-link control
messages, but recovers after an PN WARM reset.
g. Error 9905 occurs whenever the PN is unable to send up-link control
messages, but recovers after an PN COLD reset.
8-742 Issue 1 May 2002
Alarm
Associated Test Level
Any
None
None
None
None
None
None
None
On/Off
Board Test to Clear Value
None
555-233-143