Avaya S8700 Maintenance Manual page 1639

HYB-LINE (Hybrid Line)
Hybrid Line Remote Digital Looparound
Test (#59)
This test checks the digital control pair from the port circuit to the terminal. The
on-board microprocessor sends a message to the terminal and checks for a
proper return message. This test is repeated three times, with two out of the three
attempts passing being sufficient for this test to pass. This test will run if the
station is in service or out of service.
Table 8-354. Test #59 Hybrid Line Remote Digital Loop-Around Test
Error Test
Code Result Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1 ABORT A request for a remote station audit aborted even though every internal
resource was correctly allocated.
1. Look in the error log for Error Type 18 (port busied out) for this port. If this
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the station
2. If the port status is idle, then retry the command at 1-minute intervals up to
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
555-233-143
Error Type is present, release the port via the release port UUCSSpp
command or the release station extension command, and then run the
test again.
extension number of the port. Use the status station command to
determine the service state of the port. If the port is in use, wait until it is
idle before testing.
5 times.
Continued on next page
Issue 1 May 2002 8-917