Avaya S8700 Maintenance Manual page 1631

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

HYB-LINE (Hybrid Line)

Table 8-350. Test #6 NPE Crosstalk Test — Continued

Description / Recommendation

Test disabled via administration. This only applies to analog stations.

The default for this field is 'y,' so you may want to determine why it has been

turned off for this station.

1. To enable test, set the Test field on the station administration screen for the

Response to the test request was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

The test did not run due to an already existing error on the specific port or a

more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit pack

Could not allocate the necessary system resources to run this test. This could

be due to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

This test can fail due to on-board or off-board problems. Off-board problems of

concern include EXP-PN and EXP-INTF faults, TDM-BUS faults, and faults

associated with the tone detectors/tone generators. Clear every off-board

problem before replacing the board. Keep in mind that a TDM-BUS problem is

usually the result of a faulty board connected to the backplane or bent pins on

the backplane.

1. Resolve any "EXP-PN" and "EXP-INTF" errors in the error log.

2. Resolve any "TDM-BUS" errors in the error log.

3. Retest the board when the faults from steps 1 and 2 are cleared.

The port is correctly using its allocated time slots. User-reported troubles on

this port should be investigated using other port tests and by examining station,

trunk, or external wiring.

particular analog station being tested to 'y.' Use the change station

extension command.

and attempt to diagnose the already existing error.

Continued on next page

Issue 1 May 2002

Troubleshooting