Avaya S8700 Maintenance Manual page 1665

IPMEDPRO (IP Media Processor Circuit Pack)
Table 8-366. Test #1406 MP Diagnostic Test — Continued
Error Test
Code Result Description / Recommendation
24576– FAIL An ETHERNET device failed:
24580
1. Issue the busyout board UUCSS command.
2. Issue the reset board UUCSS command.
3. Issue the release board UUCSS command.
4. Issue the test board UUCSS long command.
If the board continues to fail replace the board.
PASS The FPGA device on this TN2302 is operating correctly.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Administer the
2. If the board was already administered correctly, check the error log to
3. If the board was found to be correctly inserted in step 1, then issue the
4. Issue the reset board UUCSS command.
5. Issue the release board UUCSS command.
6. Issue the test board UUCSS long command.
This should re-establish the linkage between the internal ID and the port.
555-233-143
IPMEDPRO interface if it is not already administered.
determine whether the board is hyperactive. If this is the case, the board
is shut down. Reseating the board re-initializes the board.
busyout board UUCSS command.
Continued on next page
Issue 1 May 2002 8-943