Avaya S8700 Maintenance Manual page 864

Maintenance-Object Repair Procedures
140AY Channel Sanity Inquiry Test (#222)
The Angel keeps a sanity status bit for each of the 16 channels on the 140AY
device. This test queries the Angel to determine the status of a particular channel.
If a channel is insane, announcements cannot be played back on that channel.
Table 8-55. Test #222 140AY Channel Sanity Inquiry Test
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
FAIL Test failed. Announcements cannot be played back over this port.
1. Reset the circuit pack via the reset board UUCSS command and then run
2. If there are recurring alarms on this port caused by this test failing, replace
!
PASS Announcements can be played back over this port. Investigate user-reported
troubles on this pack using other port and circuit-pack tests. Refer to the
''AN-LN-PT (Analog Line Port)''
8-142 Issue 1 May 2002
this test again. If the test continues to fail, replace the circuit pack (see
Warning).
the circuit pack even if step 1 works.
CAUTION:
Replacing the circuit pack causes a loss of integrated announcements.
Refer to ''Essential Service Information'' on page 8-120
MO.
MO for a description of the circuit pack tests.
Continued on next page
of the AN-LN-PT
555-233-143