Avaya S8700 Maintenance Manual page 1662

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

Table 8-365. Test #1379 Ping Test — Continued

Description / Recommendation

The number of pings received did not match the number sent (normally one

ping sent). This means that no ping responses were received from the

gateway defined on the ip-interfaces form for the Media processor.

1. Retry the command at 1-minute intervals up to 3 times.

The board is administered but not enabled in the change ip-interfaces form.

A ping to the destination failed through this port. This failure is because the

destination is down.

1. Verify that at least one destination is reachable through this port.

2. Once verified, execute the test port UUCSSpp command to verify that the

Ping through this port is successful.

MP Diagnostic Test (#1406)

This test is destructive.

The MP Diagnostic test (#1406) runs all of the diagnostic tests listed below, in the

order listed, but only if each successive test passes:

1. FPGA Query

2. TSI Query

3. ETHERNET Query

4. SCOTCH Sanity

This test passes if the FPGA device on the TN2302 tests okay. Otherwise, it fails

with no fail code or AUX data.

This test verifies the status of the FPGA device on the TN2302 circuit pack. If the

device is bad, software sets an appropriate counter, posts an error and alarm, and

takes all DSPs out of service (all DSPs are controlled by the one FPGA).

Software then attempts to reset the FPGA. If the reset passes or the original test

passes, the DSPs are placed into service.

Issue 1 May 2002

H.323 Signaling Group Ping test (#1387) passes.

Continued on next page

Troubleshooting