Avaya S8700 Maintenance Manual page 1669

IPMEDPRO (IP Media Processor Circuit Pack)
Long IP 2-Way Transmission Test (#1506)
This test is a non-destructive test.
Long IP 2-Way Transmission test is run for the long demand test only.
This test is used to verify IP network connectivity between a specified IP Media
processor and every other IP Media processor in the system. It is an extended
version of Test #1505.
In Test #1505 we verify IP voice connectivity in both directions, between the
specified IP Media Processor (A) and a system chosen destination IP Media
processor (B).
In Test #1506 we verify IP voice connectivity in both directions, between the
specified IP media Processor (A) and all other IP Media Processor/s (B, C, D,
E, ....) that has administered IP network region connectivity to the IP network
region, of the source IP Media processor.
The test passes if the source IP Media processor (A) has 2-way voice connectivity
to all other IP Media processors. The test fails and stops immediately when the
source IP Media processor (A) cannot verify 2-way talk path to any destination IP
Media processor. The failure code indicates the port network that contains the
destination media processor that could not be reached.
This test creates a G.711 audio path between the source IP Media processor
board specified in the command line and a destination IP Media processor board.
All destination media processor boards are chosen from the same IP network
region as the source IP Media processor and connected IP network regions. An
audio channel using G.711 is setup between a pair of boards. A 1004-Hz test
tone is transmitted from the source PN to the destination PN over the G.711 audio
channel. The test tone is then transmitted from the destination PN to the source
PN.
555-233-143 Issue 1 May 2002 8-947