Avaya S8700 Maintenance Manual page 1036

Maintenance-Object Repair Procedures
Table 8-136. Test #6 NPE Crosstalk Test — Continued
Error Test
Code Result Description / Recommendation
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present or some Tone Detectors
may be out-of-service.
1. Resolve TTR-LEV errors.
2. Resolve TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals up to 5
1004 ABORT The port was seized by a valid call during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the trunk
2. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
2020 ABORT The test did not run due to a previously existing error on the specific port or a
more general circuit pack error.
1. Examine Error Log for existing errors against this port or the circuit pack
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The Network Processing Element (NPE) of the tested port was found to be
transmitting in error. This will cause noisy and unreliable connections. This
problem may be caused by defective Tone Detectors.
1. Test every Tone-Clock circuit pack, and resolve any errors on these circuit
2. If the test fails again, replace the auxiliary trunk circuit pack.
PASS The port is correctly using its allocated time slots. User-reported troubles on
this port should be investigated using other port tests and examining station,
trunk, or external wiring.
8-314 Issue 1 May 2002
retry the command at 1-minute intervals up to 5 times.
times.
group/member number of the port. Use the status trunk command to
determine the service state of the port. If the port is active, wait until it is
idle.
and attempt to diagnose the previously existing error.
packs before any action is taken on the auxiliary trunk circuit pack. Then,
repeat the test.
Continued on next page
555-233-143