Avaya S8700 Maintenance Manual page 812

Maintenance-Object Repair Procedures
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port's message lamp state (if it has one) and
translations (such as station type, dial type, network connection) with information
kept in the software. The software is updated with the switchhook state reported
by the port processor. When the ringer is in the off state, this test also turns off the
station's ringer to prevent constant ringing caused by defective hardware.
Table 8-36. Test #36 Station Status and Translation
Audits and Updates Test
Error Test
Code Result Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1004 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the station
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort and the port is idle, escalate the problem.
1005 ABORT The test was aborted due to a configuration problem. This code results under
either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
2. The circuit pack is one of the following:
1006 ABORT This port has been busied out by command or taken out-of-service by the
failure of the NPE Crosstalk test.
1. Look in the Error Log for Error Type 18 (port busied out) for this port. If this
2. Look in the Error Log for Error Type 1025 (NPE Crosstalk test failed) for
3. Make sure that the terminal is connected and in service, and then retest.
8-90 Issue 1 May 2002
extension. Use the status station command to determine the service
state of the port. If the service state indicates that the port is active, then
the port is unavailable for certain tests. Wait until the port is idle before
retesting.
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
— TN742 vintages 13,14, and 15
— TN769 vintages 3, 4, and 5
error is present, then release the port with the release station extension
command and run the test again.
this port. If this error is present, then investigate the errors associated with
the NPE Crosstalk test (#6) first.
Continued on next page
555-233-143