Avaya S8700 Maintenance Manual page 1645

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

HYB-LINE (Hybrid Line)

Hybrid Line Ringer Update Test (#62)

In this update, a ''ringer on'' or a ''ringer off'' message is sent to the firmware to

start and stop the ringer on the set.

Table 8-357. Test #62 Hybrid Line Ringer Update Test

Description / Recommendation

This port may have been busied out by system technician.

1. Look in the Error Log for Error Type 18 (port busied out) for this port. If this

2. Make sure that the terminal is connected.

3. Retry the command at 1-minute intervals up to 5 times.

System resources required to run this test are not available. The port may be

busy with a valid call.

1. Use the display port UUCSSpp command to determine the station

2. If the port status is idle, then retry the command at 1-minute intervals up to

This port is currently a TTI port and the test will not execute on it.

1. Verify that the port is a TTI port using either the display port command

2. If either list config or display port indicate that the port is not a TTI port,

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

Hybrid Station Ringer Update passed

1. If complaints still exist, investigate using other circuit pack tests on this

Error Type is present, release the port via the release station extension

command and run the test again.

extension number of the port. Use the status station command to

determine the service state of the port. If the port is in use, wait until it is

idle before testing.

(the display shows that the port is a TTI port) or the list config command

(the display shows a

for the port).

escalate the problem. If both commands indicate that the port is a TTI port,

the abort is correct, and no action is necessary.

circuit pack, and by examining the terminal, wiring, and connections.

Continued on next page

Issue 1 May 2002

Troubleshooting