Avaya S8700 Maintenance Manual page 830

Maintenance-Object Repair Procedures
Table 8-41. Test #7 Conference Circuit Test — Continued
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available.
1. Resolve any TONE-PT errors in the error log.
2. If there are no TONE-PT errors, retry the command at 1-minute intervals
3. If the test continues to abort, escalate the problem.
Any FAIL The NPE of the tested port did not conference the tones correctly. This causes
noisy and unreliable connections.
1. Issue the display port UUCSSpp and the status station extension
2. If the station is idle, issue the test port UUCSSpp command for this port.
3. If the test continues to fail, issue the busy port UUCSSpp and the release
4. If the test still fails, replace the board.
PASS The port can correctly conference multiple connections. Investigate
user-reported troubles on this port by running other port tests; by examining
station, trunk, or external wiring; or by inspecting the station.
0 NO The test could not relate the internal ID to the port (no board). This result could
BOARD be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to make sure that the board translations are correct. Use the list
2. If the board is correctly inserted, issue the busy board UUCSS command.
3. Issue the reset board UUCSS command.
4. Issue the release board UUCSS command.
5. Issue the test board UUCSS long command.
8-108 Issue 1 May 2002
up to 5 times.
commands to determine whether the station is idle.
port UUCSSpp commands, and then retest.
configuration command, and resolve any problems.
This should re-establish the link between the internal ID and the port. If
not, verify that a valid board is inserted.
Continued on next page
555-233-143