Avaya S8700 Maintenance Manual page 757

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

ADX16A-PT (AUDIX Analog Line/Control Link)

Error Log Entries and Test to Clear Values

Table 8-12. EMBEDDED AUDIX Analog Line/Control Link Error Log Entries

Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate

test's description, and follow its recommended procedures.

Minor alarms on this MO may be downgraded to Warning alarms based on the values used in the set options

a. This is an in-line error and can only be resolved over time. This indicates

that no terminal equipment was present when ringing was attempted.

Execute the short test port UUCSSpp command.

b. The circuit pack has been logically administered but not physically

installed. The alarm will be cleared when the circuit pack is installed.

c. The circuit pack has been removed or has been insane for more than

11 minutes. To clear the error, reseat or replace the circuit pack.

d. This is an in-line error and can only be resolved over time. This error

indicates that ringing voltage is absent. If only one analog circuit pack in

the system has this problem, then replace the circuit pack. If only analog

circuit packs on a particular carrier have this error, then the ringing

generator may not be connected to this carrier. If analog circuit packs on

many carriers have this error, check the ringing generator.

e. AUDIX is not available to the switch. Check the AUDIX system, referring to

EMBEDDED AUDIX System Maintenance, 585-300-110.

f. The TDM bus is out of service. See

Associated Test

busyout station

Looparound test

Conference test

NPE Crosstalk

Test to Clear Value

test port UUCSSpp sh r 1

release station extension

test port UUCSSpp sh

test port UUCSSpp l r 2

''TDM-BUS (TDM Bus)'' on page

Issue 1 May 2002

Troubleshooting