Avaya S8700 Maintenance Manual page 1658

Maintenance-Object Repair Procedures
Table 8-362. Test #53 SAKI Sanity Test
Error Test
Code Result Description / Recommendation
None ABORT System resources required for this test are not available.
Retry the command at 1-minute intervals up to 5 times.
1015 ABORT Port is not out of service.
1. Busy out the circuit pack.
2. Execute command again.
2100 ABORT System resources required for this test are not available.
Retry the command at 1-minute intervals up to 5 times.
2803 ABORT It is necessary to reset the board.
1. Use the change ip-interfaces form to disable the Media processor IP
2. Execute the command again.
1 FAIL The circuit pack failed to reset.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
2, FAIL The circuit pack failed to restart.
2000
1. Execute command again.
2. If the problem persists, replace the circuit pack.
PASS The circuit pack initializes correctly.
Run the short test sequence.
Any NO This is normal if the test is being done when (a) the board is not physically in
BOARD the system or (b) the system is booting up. Otherwise, there is some
inconsistency between the physical configuration and the data kept in the
system.
1. Verify that the board is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at 1-minute intervals for up to 5 times.
8-936 Issue 1 May 2002
interface.
Continued on next page
555-233-143