Avaya S8700 Maintenance Manual page 917

ATM-EI (Expansion Interface Circuit Pack)
Table 8-81. ATM Error Types 1024 - 1151
Error Type Description
1024 Next node unreachable
1056 DTL Transit not my node ID
1088 or ATM-EI circuit pack received a request with an
1104 invalid connection identifier.
1089 or ATM-EI circuit pack received a request with a
1105 reference to an unknown VC token.
1090 or ATM-EI circuit pack did not have enough
1106 resources (memory) for the requested operation.
1091 or Internal failure in the local protocol stack. This
1107 can occur when the connection to the ATM switch
failed, perhaps because the:
ATM switch rebooted
fiber between the ATM switch and the
ATM-EI circuit pack disconnected
1092 or ATM-EI circuit pack received a request for which
1108 the referenced VC was in the wrong call state.
1093 or ATM-EI circuit pack received a request for which
1109 the VPI/VCI pair was invalid or out of range.
1094 or ATM-EI circuit pack received a request to add a
1110 party to an existing VC. The add party request
failed, and a retry was not possible.
1095 or ATM-EI circuit pack in link recovery after the
1111 lower ATM layer (Q.SAAL portion of the protocol
stack) failed. This can occur when the connection
to the ATM switch failed, perhaps because the:
ATM switch rebooted
fiber between the ATM switch and the
ATM-EI circuit pack disconnected
1096 or ATM-EI circuit pack received an error from the
1112 local protocol stack for which no more detailed
cause was specified.
1102 ATM-EI circuit pack asked to create more
connections that it was capable of creating.
1103 ATM-EI circuit pack detected an illegal message
from software.
Check the Error Log for CONN-M proc errors for
more information.
1113
555-233-143
General problem
ATM protocol stack on ATM-EI
circuit pack
Firmware-detected problems on the
ATM-EI circuit pack. Note: Error
Types 1088–1103 are reported by
the board that is originating the
connection. Error Types
1104–1119 are reported by the
board that is terminating the
connection. In most cases, when
the terminating board reports one of
these errors, the originating board
also reports an ATM-NTWK error
for the same event (usually with
Error Type 21).
Problems detected by the board
terminating the connection
Issue 1 May 2002 8-195