Avaya S8700 Maintenance Manual page 1593

FW-DWNLD (Firmware Download)
TN799DP (C-LAN) Firmware Download
To update the firmware on the TN799DP (C-LAN) circuit pack, do the following:
1. Set up a file system on a source board and an FTP login to the system by
executing the command enable filesystem.
2. FTP the firmware image file onto the source board where the file system
was enabled.
3. Execute the list directory command. Verify that the image is on the
source board.
4. Execute the change firmware download command. Set up the download
schedule.
5. If a start time has been entered and the schedule is pending, verify the
schedule by executing the test firmware download command.
6. Execute the status firmware download [last] command. This command
allows you to view the status of the download. If there are no errors/alarms
the status is copied over to the last table.
7. If the system does a reset 1 or 2 and no alarms are present, execute the
display init cause command. Clear any errors and retest by executing the
test firmware download command.
8. If errors/alarms exist they can be resolved/cleared by executing the test
firmware download command.
9. If there are no errors/alarms and the Remove File option is set to y on the
firmware download screen, the image file is removed from the source
board and the file system is disabled. If the Remove File option is set to n,
the file can be removed by executing the remove file command.
10. Execute the disable file system command to disable the firmware
download file system and FTP login on the source (C-LAN or VAL) board.
TN2501AP (VAL) Firmware Download
The TN2501AP Voice Announcements over the LAN (VAL) circuit pack provides
the ability to download new versions of the firmware to itself. That is, the circuit
pack serves as both the source and the target for the firmware image file.
NOTE:
The TN2501 VAL board cannot be used as a source board to download
other circuit packs.
555-233-143 Issue 1 May 2002 8-871