Avaya S8700 Maintenance Manual page 1112

Maintenance-Object Repair Procedures
Table 8-162. Test #122 Cabinet Temperature Query Test — Continued
Error Test
Code Result Description / Recommendation
1 FAIL NONVARIABLE-SPEEDFAN ASSEMBLIES (older or upgraded cabinets):
The AHD1 circuit pack has reported an air-flow problem. The temperature
(cont'd) (cont'd)
difference between the air intake and the air exhaust is at least 15
and the absolute temperature at the top of the cabinet is at least 50
The fans should be running at high speed. If none of the fans are running
then:
1. Look for an resolve every alarm against CARR-POW.
2. Verify that 48 VDC is available to the fan wiring harness connector
3. If the fans still do not run, escalate the problem.
4. If 48 VDC is absent, replace the CFY1B current limiter card.
5. If every fan can then be started, wait 5 minutes, and rerun the test. If the
6. If every fan is running but not at high speed, measure the cabinet
8-390 Issue 1 May 2002
between pin pairs 2/3, 8/9, and 10/11. The tolerable range for this
measurement is -42.5 V to -52.5 V.
If 48 VDC is present and the fans are not running, replace the AHD1
circuit pack.
If the fans still do not run, escalate the problem.
If some fans are running and some not, replace the defective fans.
test fails again, proceed to the next step.
temperature at the air intake and the air exhaust at the top of the cabinet.
0 0
a. If the 15 -/50 -C criteria is met, there is a problem with the AHD1
circuit pack or the fans. Replace the AHD1 circuit pack and/or fans. If
the fans run at high speed, wait 5 minutes for the cabinet to cool, then
retest. If the test fails, escalate the problem.
0 0
b. If the 15 -/50 -C criteria is not met, an EPN's Maintenance circuit pack
is incorrectly reporting this condition. Resolve every MAINT error and
retest. If the test fails, escalate the problem.
0 0
C (59 F))
0 0
C (122 F).
Continued on next page
555-233-143