Avaya S8700 Maintenance Manual page 902

Maintenance-Object Repair Procedures
Table 8-74. Test #258 ISDN Test Call — Continued
Error Test
Code Result Description / Recommendation
1020 ABORT TN230x circuit-pack problem
1. See the
1024 ABORT Maintenance/Test digital port active
1. Wait until amber and green LEDs on the Maintenance/Test circuit pack are
2. Rerun the test.
3. If the problem persists, see
1113 ABORT Signaling link failed
1. Check the results of Test #255 (Signaling Link State Check test).
1116 ABORT Switch could not change the service state
1. See if calls are active. Run status trunk grp#/mbr#.
2. If a call is active, proceed as for Error Code 1119.
1117 ABORT ISDN service message outstanding
1. Wait 2 minutes. Then try again.
1118 ABORT Far-end not administered
1. Check the administration of the far end of the ATM trunk. Run status
2. Try the test again.
1119 ABORT Test call aborted, normal call attempted
1. Wait for the call to finish normally, or drop it by running busyout trunk
2. When the trunk is idle, retry the test.
1120 ABORT Trunk OUT-OF-SERVICE/FAR-END
1. Try to change the service state via Test #256 (Service State Audit test).
2. Try the test again.
1122 ABORT No test-line number for the far-end switch
1. Check the Trunk Group Administration form.
1123 ABORT No Feature Access Code administration for this Facility test
1. Check the Dial Plan and Feature Administration forms.
8-180 Issue 1 May 2002
''ATM-INTF (TN2305/6)''
OFF.
MO.
If not, check the Error and Alarm Logs and see
Emulation Service Circuit
trunk grp#/mbr#.
grp#/mbr#.
MO.
''M/T-DIG (Maintenance/Test Digital Port)''
''ATM-TRK (Circuit
Pack)''.
Continued on next page
555-233-143