Avaya S8700 Maintenance Manual page 774

Maintenance-Object Repair Procedures
Table 8-21. Test #7 Conference Circuit Test — Continued
Error Test
Code Result Description / Recommendation
1004 ABORT The port was seized by a valid call during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the station
2. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018 ABORT The test has been disabled via administration. The default for the
on the station form is y. Determine why this field has been set to "n" on this
station (this may be due to the ringing application Test #48, which can be
customer or terminal disturbing).
1. To enable the test for the particular analog station being tested, enter
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available.
1. Resolve any TONE-PT errors.
2. Resolve any TONE-PT errors.
Any FAIL The NPE of the tested port did not conference the tones correctly. This will
cause noisy and unreliable connections.
1. Issue the display port and the status station commands to determine
2. If the test continues to fail, issue the busyout port and the release port
3. If the test still fails, replace the board.
8-52 Issue 1 May 2002
extension. Use the status station command to determine the service
state of the port. If the port is active, wait until it is idle.
change station extension and set the
whether the station is idle. If the station is idle, issue the test port
command for this port.
commands, and then retest.
Test
field on the station to y.
Test?
Continued on next page
555-233-143
field