Avaya S8700 Maintenance Manual page 1685

IP-SVR (IP Server Interface)
Table 8-378. IPSI LEDs
Function LED
TN2312AP Red
circuit pack
status
Green
Amber
Clock status Amber
(same as
TN2182B)
Push-Button Switch
The push-button switch is used to administer the switch ID and the cabinet
number of the IPSI. This button can also be used to erase the manually
programmed IP address. Inserting the IPSI board with the button pressed or just
resetting it while the button is pressed will keep the IPSI in boot mode.
555-233-143
State Description
On/Off TN2312AP circuit pack alarm (controlled by
both the PKT-INT and the Tone-Clock Angel;
logically or-ed together)
On/Off TN2312AP test in progress (controlled by
both the PKT-INT and the Tone-Clock Angel;
logically or-ed together)
Off Archangel inactive
Flashing Archangel active
2 sec on
0.2 sec off
Flashing Active: Master clock, using offboard
synchronization source.
2.7 sec on
0.3 sec off
Winking Active: Master clock, using its local reference
source.
0.3 sec on
2.7 sec off
Steady on Active: Board has been reset and is providing
clocks but has not been told which
synchronization source to use.
Steady off Standby: Applying no tones to the network.
"Jingle Bells" Standby: Tone generator is being used.
Green and Amber
0.1 sec on, 0.2 sec off,
0.1 sec on, 0.4 sec off,
0.4 sec on, 0.4 sec off
Double blink Active: Lost all external references and is in
Amber holdover mode.
0.3 sec on, 0.3 sec off,
0.3 sec on, 2.4 sec off
Random Standby: This LED may come on and off
intermittently as ETR-PTs on the board are
used for tone-detection services.
Issue 1 May 2002 8-963