Avaya S8700 Maintenance Manual page 1101

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

BRI-SET, ASAI-ADJ, BRI-DAT

BRI Set Audits Test (#630)

This is a series of two tests that are classified as audits. The switch sends

messages to the BRI endpoint to perform the following tests:

Ringer Audit – This audit insures that both the switch and the endpoint

agree as to the current state of the endpoint's ringer.

Lamps Audit – This audit insures that both the switch and the endpoint

agree as to the current state of the endpoint's lamps.

Call Activity Audit – This audit insures that the state of calls is consistent

between the switch and the endpoint.

This test is not executed for ASAI or Avaya adjunct because adjuncts do not

employ ringers or lamps, or establish calls on the B channels associated with the

BRI interface.

Table 8-159. Test #630 BRI Set Audits

Description / Recommendation

The signaling link between the switch and the endpoint is down.

1. Use the test port PCSSpp long command to clear any errors that prevent

2. Examine the results of the Signaling Link Status test (#626) that is run as

3. If the BRI Set Audits test continues to abort, escalate the problem.

The EPN's packet bus is out-of-service.

1. Follow the repair procedures for the packet bus.

2. After completing step 1, execute the test port long PCSSpp command,

The PKT-CTRL is out-of-service.

1. Refer to PKT-CTRL (Packet Control Circuit Pack) Maintenance

2. If step 1 does not resolve the problem, escalate to the next tier.

establishment of the signaling link.

part of this command. If this test aborts or fails, follow the repair procedure

for Test #626.

and review the results of the BRI Port Local LAN Loop Around test (#618)

to verify the repair.

documentation.

Continued on next page

Issue 1 May 2002

Troubleshooting