Avaya S8700 Maintenance Manual page 1299

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

DIOD-TRK (DIOD Trunk)

System Technician-Demanded Tests:

Descriptions and Error Codes

Always investigate tests in the order they are presented in the table below. By

clearing error codes associated with the NPE Crosstalk test, for example, you

may also clear errors generated from other tests in the testing sequence.

Order of Investigation

NPE Crosstalk test (#6)

Dial Tone test (#0)

Looparound and Conference test (#33)

Audit Update test (#36)

D = Destructive; ND = Nondestructive

Dial Tone Test (#0)

This test attempts to seize a port and checks for the return of a dial tone.

Table 8-234. Test #0 Dial Tone Test

Description / Recommendation

Could not allocate system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

System resources required to run this test are not available. The port may be

busy with a valid call.

1. Use the command display port UUCSSpp to determine the trunk

2. If the port status is idle, then retry the command at 1-minute intervals up to

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

The system could not allocate time slots for the test. The system may be under

heavy traffic conditions or it may have time slots out-of-service due to

TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic,

group/member number of the port. Use the status trunk command to

determine the service state of the port. If the service state indicates that

the port is in use, then the port is unavailable for certain tests. Wait until

the port is idle before retesting.

repeat test at 1-minute intervals up to 5 times.

Continued on next page

Issue 1 May 2002

Troubleshooting