Avaya S8700 Maintenance Manual page 1686

Maintenance-Object Repair Procedures
4-Character LED
The 4-character LED is used to display the circuit pack status related to the
Ethernet interfaces. If automatic IP address assignment via DHCP is enabled, the
top character displays the Switch ID and the next two characters display the
Cabinet Number. The last character is used to display the link status of the two
Ethernet interfaces.
Services Interface
The top RJ45 jack is the services interface. This is a 10/100 BaseT Ethernet
interface.
Control Network Interface
The bottom RJ45 jack is the control network interface. This is a 10/100 BaseT
Ethernet interface. This interface is active only when the IPSI I/O adapter is not
plugged onto the Amphenol connector, located on the rear of the carrier.
PN's Maintenance Board Interface
The PN's Maintenance board interface is a header on the IPSI circuit pack with a
slit on the faceplate of the IPSI for the ribbon cable to connect to the PN's TN755D
Maintenance board.
Error Log Entries and Test to Clear Values
Table 8-379. LIC-ERR Error Log Entries
Error Aux
Type Data
18 (b) 0
Notes:
Error Type 18—This error type is logged when the IPSI circuit pack in
question is busied out by maintenance personnel. Make sure the IPSI
circuit pack is released from busyout via the release ipserver-interface
Uc command.
System Technician-Demanded Tests:
Descriptions and Error Codes
There are no system technician demand tests as such for this MO.
8-964 Issue 1 May 2002
Alarm
Associated Test Level
busyout ipserver- WARNING
interface Uc
On/Off
Board Test to Clear Value
OFF release ipserver-
interface Uc
555-233-143