Avaya S8700 Maintenance Manual page 1160

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

h. Error Type 1793—DS1 Interface circuit pack is out-of-service. Look for

DS1-BD errors in the Hardware Error Log if the port is on a TN767 DS1

board. Look for UDS1-BD errors in the Hardware Error Log if the port is on

a TN464 UDS1 board. See

''UDS1-BD (UDS1 Interface Circuit Pack)'' on page 8-1707

i. Error Type 2562—Retry Failure error. This error is logged only. It is not a

hardware failure and hence does not start any testing or generate any

alarms. This error comes from call processing and is generated when a

second attempt (retry) to seize an outgoing trunk fails.

j. Error Type 2817—Glare error. This error is logged only. It is not a

hardware failure and hence does not start any testing or generate any

alarms. This error is the result of a simultaneous seizure of a 2-way trunk

from both the near and far ends. Attempt to place the call again. If the

error persists, execute the Dial Tone Seizure test (#314), and follow those

k. Error Type 3840—Port Audit and Update test (#36) failed due to an internal

system error. Enter the status trunk command to verify the status of the

trunk. If the trunk is out-of-service, then enter the release trunk command

to put it back into in-service. Retry the test command.

Issue 1 May 2002

''DS1-BD (DS1 Interface Circuit Pack)''

Troubleshooting