Avaya S8700 Maintenance Manual page 1614

Maintenance-Object Repair Procedures
System Technician-Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order presented in the table below when inspecting
errors in the system. For example, by clearing error codes associated with the
CLAN Ethernet Status test (#1386), you may also clear errors generated from
other tests in the testing sequence.
Order of Investigation
CLAN Ethernet Status test (#1386)
MedPro Status test (#1392)
H.323 Signaling Group Ping test (#1387)
1. D = Destructive; ND = Nondestructive
CLAN Ethernet Status Test (#1386)
This test is nondestructive.
This test checks the status of the C-LAN ethernet port that originated this
signaling group. If the C-LAN ethernet port is in service, the test passes; if it is
OOS (out of service), the test fails.
NOTE:
Failure of this test will put the SIG-GRP in the OOS state.
Table 8-341. Test #1386 CLAN Ethernet Status Test
Error Test
Code Result Description / Recommendation
1125 ABORT Ethernet Link is not in service.
1. Check if the ethernet link is in service or not. If the link is not in service,
2. If the test continues to abort after following the repair procedures, escalate
8-892 Issue 1 May 2002
release the link using release link n or the release port UUCSSpp
command and repeat the test. This is a normal abort.
the problem.
Short Test Long Test
Sequence Sequence
X X
X X
X X
Continued on next page
1
D/ND
ND
ND
ND
555-233-143