Avaya S8700 Maintenance Manual page 740

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

d. The port is busied-out by command. You can release the port via the

release port UUCSSpp command.

e. The circuit pack is administered but not physically installed. The alarm will

clear when a circuit pack is inserted.

f. The circuit pack has been removed or has been insane for more than

21-minutes. To clear the error, reinsert or replace the AUDIX circuit pack

(see Caution at the beginning of this section).

g. Something is interfering with transmission to the voice port. This is usually

an on-board problem and can be ignored if there are no user complaints.

h. AUDIX is not available to the switch, possibly due to a busyout on the

AUDIX system. Check out the AUDIX system referring to EMBEDDED

AUDIX System Maintenance, 585-300-110, if necessary.

i. An in-line maintenance error has generated an off-board warning due to

some problem with the link to the voice port. This can be ignored if there

are no user complaints. If the problem persists, replace the circuit pack

(see Caution at the beginning of this section). Once the problem is

resolved, the alarm is retired after a certain period of time.

j. The link between the circuit pack and the voice port is successfully reset.

No craft action is necessary.

k. No voice ports are connected to the EMBEDDED AUDIX circuit pack. No

maintenance action is required.

l. The message buffer in the circuit pack is full.

System Technician-Demanded Tests:

Descriptions and Error Codes

Always investigate tests in the order presented in the table below when you are

inspecting errors in the system. For example, by clearing error codes associated

with the Voice and Control Channel Local Looparound test (#13), you may also

clear errors generated from other tests in the testing sequence.

Order of Investigation

Voice and Control Channel Local Looparound test (#13)

NPE Crosstalk test (#9)

D = Destructive; ND = Nondestructive

Issue 1 May 2002

Troubleshooting