Avaya S8700 Maintenance Manual page 807

ANL-LINE, ANL-NE-L (8-Port Analog Line)
Table 8-34. Test #6 NPE Crosstalk Test — Continued
Error Test
Code Result Description / Recommendation
1004 ABORT The port was seized by a valid call during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the station
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort and the port is idle, escalate the problem.
1005 ABORT The test was aborted due to a configuration problem. This code occurs under
either of the following conditions:
1018 ABORT Test disabled via administration. The default for the
form is y; thus, you may want to determine why this field has been set to n on
this station (this may be due to the ringing application test 48, which can be
customer or terminal disturbing).
1. To enable the test for a particular station, enter change station extension
1020 ABORT The test did not run due to a previously existing error on the specific port or a
more general circuit pack error.
1. Examine Error Log for existing errors against this port or the circuit pack
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available. Either a system
allocation to get information about the port or to put the port into a service state
failed or the attempt to put the port in connection with a tone source failed (this
could be a Tone-Clock problem). The Tone-Clock and Tone Detectors could
be having a communication problem. (For example, the companding modes
could be out of synchronization.)
1. Retry the command at 1-minute intervals up to 5 times.
555-233-143
extension. Use the status station command to determine the service
state of the port. If the service state indicates that the port is active, then
the port is unavailable for certain tests. Wait until the port is idle before
retesting.
This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, a modem pool
member or music on hold).
The circuit pack is one of the following:
— TN742 vintage 13, 14, or 15
— TN769 vintage 3, 4, or 5
and set the Test? field to y.
and attempt to diagnose the previously existing error.
Test? field on the station
Continued on next page
Issue 1 May 2002 8-85