Avaya S8700 Maintenance Manual page 742

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

Maintenance-Object Repair Procedures
Table 8-7. Test #9 NPE Crosstalk Test — Continued
Error
Test
Code
Result
Description / Recommendation
1001
ABORT
System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1002
ABORT
The system could not allocate time slots for the test. The system may be under
heavy traffic conditions, or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003
ABORT
The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present, or some Tone Detectors
may be out of service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. Retry the command at 1-minute intervals up to 5 times.
1004
ABORT
The port was put in use during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the voice port
1020
ABORT
Test disabled by background testing. Use the status station command to
determine when the voice port is available for testing.
2000
ABORT
Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
1, 2
FAIL
The NPE of the tested port is transmitting in error. This causes noisy and
unreliable connections. Failure code 1 indicates that the Crosstalk test failed
on the primary channel. Failure code 2 indicates that the Crosstalk test failed
on the secondary channel.
1. Replace the circuit pack.
PASS
The port is using its allocated time slots correctly.
1. To be sure that this is not an intermittent problem, repeat this test up to 10
2. If complaints still exist, examine the connections.
8-20
Issue 1 May 2002
retry the command at 1-minute intervals up to 5 times.
extension of the port. Use the status station command to determine the
service state of the port. If the port is active, wait until it is idle before
testing.
times to make sure it continues to pass.
Continued on next page
555-233-143

Advertisement

Table of Contents
loading

Table of Contents