Avaya S8700 Maintenance Manual page 956

Maintenance-Object Repair Procedures
Table 8-99. Error codes and Aux data values ATM-NTWK
Cause Code/ Aux
Error Type Data Cause Codes Description
23 (a) User rejects every call with CLIR (calling line identification restriction). This
cause is returned by the called party when the call is offered without calling
party's number information and the called party requires this information.
27 (a) Destination out of order. This cause indicates that a user-indicated destination
cannot be reached because a signaling message could not be delivered to the
remote user over the destination's interface (for example, a physical-layer or
SAAL failure at the remote user, or remote user's equipment is off line).
28 (a) Invalid number format (address incomplete). This cause indicates that the
called user cannot be reached because the called party's number is not in a
valid format or has insufficient digits.
30 (a) Response to STATUS ENQUIRY. This cause is included in the STATUS
message when the reason for generating the STATUS message was the prior
receipt of a STATUS ENQUIRY message.
31 (a) Normal, unspecified. When no more specific cause values apply, this cause
reports a normal event.
32 (a) DTL transit not-my-node ID
RESOURCE UNAVAILABLE
35 (a) Requested VPCI/VCI not available. This cause indicates that the requested
VPCI/VCI is not available. This can be caused by mismatched VCI ranges on
different ATM switches.
36 (a) VPCI/VCI assignment failure
37 (a) User Cell Rate not available
38 (a) Network out of order. This cause indicates that the network is not functioning
correctly and that the condition is likely to last a relatively long time.
(Immediately retrying the call is unlikely to succeed.)
41 (a) Temporary failure. This cause indicates that the network is not functioning
correctly, but the condition is unlikely to last long. (Immediately retrying the
call is likely to succeed.)
43 (a) Access information discarded. This cause indicates that the network could not
deliver access information to the remote user as requested (that is, ATM
adaptation-layer parameters, Broadband low-layer information, Broadband
high-layer information, or sub-address as indicated in the diagnostic).
45 (a) No VPCI/VCI available. This cause indicates that no appropriate VPCI/VCI is
currently available to handle the call.
47 (a) Resource unavailable, unspecified. When no more specific cause values
apply, this cause reports a resource-unavailable event.
8-234 Issue 1 May 2002
Continued on next page
555-233-143