Avaya S8700 Maintenance Manual page 1258

Maintenance-Object Repair Procedures
Table 8-216. Test #16 DIG-LINE Station Lamp Updates Test
Error Test
Code Result Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1 ABORT This port could have been busied out by system technician.
1. Look in the Error Log for Error Type 18 (port busied out) for this port. If this
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
3 ABORT Station could be in ready-for-service or out-of-service state.
1. Use status station command to verify state of station.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port could be
busy with a valid call.
1. Use display port UUCSSpp to determine the station extension of the port.
1. If the port status is idle, then retry the command at 1-minute intervals up to
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS The message to light every station lamp was successfully sent to the port.
Digital Terminal Audits Test (#17)
This is a series of tests that are classified as audits. The media server sends
messages to the softphone application or IP phone to perform the following tests.
These audits run only if the station is in-service.
Switchhook Inquiry test
according to the softphone switch-hook state.
Ringer Update test
to the media server's records.
ID Request
8-536 Issue 1 May 2002
error type is present, then release the port via the release station
extension command and run the test again.
Use status station to determine the service state of the port. If the port is
in use, wait until it is idle before testing.
5 times.
—
This updates the media server's records
—
This updates the softphone's ringer state according
—
This queries the station for its status.
555-233-143