Avaya S8700 Maintenance Manual page 1281

DIG-LINE (Digital Line)
Ringer Update test
according to the processor records.
DTMF Administration Update test
to refresh the default value that causes the station to send touch- tones
only in the primary information channel. This value is set initially when the
station is put in-service and every time the station's state changes from
other states to in-service state.
Table 8-225. Test #17 Station (Digital) Audits Test
Error Test
Code Result Description / Recommendation
1 ABORT Switchhook audit timed out.
2 ABORT ID request fails, health bit returned from voice terminal is bad.
1. Make sure voice terminal is connected and repeat test.
2. If test fails, replace voice terminal and repeat test.
3 ABORT The EPF/PTC has detected an overcurrent condition.
1. For a TN754 vintage 13 or earlier Digital Line circuit pack, use test
2. Look for Error Type 769 logged against DIG-LINE and follow the
4 ABORT Internal system error
1. Resolve any outstanding circuit pack maintenance problems.
2. Retry the command at 1-minute intervals up to 5 times.
5 ABORT Ringer update aborted due to station being in ready-for-service or
out-of-service state.
6 ABORT This port may have been busied out by system technician.
1. Look in the Error Log for Error Type 18 (port busied out) for this port. If this
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required for this test are not available.
555-233-143
—
This updates the digital telephone ringer state
UUCSSpp long.
If Test #11 passes, then the EPF/PTC condition was cleared.
Rerun the Short Test Sequence.
If Test #11 does not pass, follow the repair procedures described
for Test #11.
procedures in the associated footnote. If any additional problems are
found, rerun the test.
error is present, the release the port via release station extension.
—
This is a message to the digital station
Continued on next page
Issue 1 May 2002 8-559