Avaya S8700 Maintenance Manual page 881

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Figure 8-2. BRI Port Local LAN Loop-Around Path

Table 8-61. Test #618 BRI Port Local LAN Looparound

Description / Recommendation

The port is not in the out-of-service state.

1. Display the Port Status form using the status bri-port UUCSSpp

2. Use the extension shown on this form in the status station command to

3. If the port is active, wait until it is idle, and use the busyout port UUCSSpp

The EPN's packet bus is out-of-service.

1. Follow the repair procedures for the packet bus.

2. After completing step 1, execute the test port long UUCSSpp command

command to determine which stations or adjuncts are on this port.

determine whether the station or adjunct is active.

command to place it in the out-of-service state and repeat this test.

Since the "busyout" command is destructive, using this command prior to

the port being idle causes every transaction associated with the ASAI on

the port to be torn down. Note that 3

adjunct remain connected even though the port is taken out-of-service.

and review the results of the BRI Port Local LAN Looparound test to verify

-party calls established by an ASAI

Continued on next page

Issue 1 May 2002

Troubleshooting