Avaya S8700 Maintenance Manual page 1539

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

EXP-INTF (Expansion Interface Circuit Pack)
Table 8-311. Test #224 Expansion Interface Test — Continued
Error
Test
Code
Result
Description / Recommendation
9999
ABORT
EI circuit pack reset successfully. Could not perform initialization test results
query because link to PN is not up.
1. Execute release board PCSS. Wait one minute. Issue the display error
12000
ABORT
EI circuit pack reset successfully. Response to the initialization test results
query was not received within the allowable time period.
12100
ABORT
EI circuit pack reset successfully. System resources required to run
initialization test are not available.
1. Retry the command at 1-minute intervals up to 3 times.
12026
ABORT
EI circuit pack reset successfully. It responded with an unknown reply to the
query for the results of its initialization tests.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the test continues to abort, replace the circuit pack or transceiver.
1
FAIL
The EI did not successfully reset.
1. If the EI circuit pack is in the PN, the PN's Maintenance board may be
2. If step 1 was not successful in releasing the EI circuit pack, temporarily
3. Repeat the reset board PCSS command.
4. If reset continues to fail, replace circuit pack.
5. Insert PN's Maintenance circuit pack if it was removed.
2
FAIL
The EI circuit pack was successfully reset, but it did not begin running after the
reset.
1. If the EI circuit pack is in the PN, temporarily remove the PN's Maintenance
2. Repeat the reset board PCSS command.
3. Re-insert the PN's Maintenance circuit pack if it was removed.
555-233-143
command. If you see Error Type 2049 logged against this EI circuit pack,
then the EI Test has failed with an error code equal to the aux data of this
entry. Otherwise, the initialization tests have passed.
holding the EI circuit pack reset. Attempt to rectify this condition by
executing the test maint P long command on the Maintenance board in
the same PN.
remove the PN's Maintenance circuit pack.
circuit pack.
Continued on next page
Issue 1 May 2002
8-817

Advertisement

Table of Contents
loading

Table of Contents