Avaya S8700 Maintenance Manual page 1228

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

Maintenance does not start any testing or generate any alarms in response

to these errors.

b. Error Type 15—This is a software audit error that does not indicate any

hardware malfunction. Run short test sequence, and investigate errors (if

c. Error Type 18—The trunk has been taken out of service by a demand

busyout. No calls can be made on this trunk.

d. Error Type 130—This error type indicates that the circuit pack has been

removed or has been insane for more than 11 minutes. To clear the error,

reinsert or replace the circuit pack.

e. Error Type 257—DS1 Interface circuit pack detects a hardware error on

the DS1 DID trunk. The Aux Data field indicate the source of the error:

f. Error Type 513—DS1 Interface circuit pack detects a hardware error on

the DS1 DID trunk. Aux Data 57392 indicates no external release on PBX

g. Error Type 769—DS1 Interface circuit pack detects a hardware error on

the DS1 DID trunk. Aux Data 57393 indicates belated external release on

PBX disconnect.

h. Error Type 1793—DS1 Interface circuit pack is out-of-service. Look for

DS1-BD/UDS1-BD errors in Hardware Error Log. Refer to the appropriate

"DS1-BD/UDS1-BD" information for details.

i. Error Type 2305—This error indicates that a signaling change was

detected by the PBX trunk circuit pack which is inconsistent with the

present state of the trunk.

j. Error Type 3840—Port Audit and Update test (#36) failed due to an

internal system error. Enter status trunk command to verify the status of

the trunk. If the trunk is out-of-service, then enter the release trunk

command to put it back to in-service. Retry the test command.

Issue 1 May 2002

Rotary dial rate above 12 pulses per second

Rotary dial rate below 8 pulses per second

Troubleshooting