Avaya S8700 Maintenance Manual page 1726

Maintenance-Object Repair Procedures
Table 8-398. Test #256 Service State Audit Test — Continued
Error Test
Code Result Description / Recommendation
1114 ABORT The signaling link is in a transitional state.
1. Retry the command at 1-minute intervals up to 5 times.
1116 ABORT The trunk is not in the out-of-service/far-end state that is required to run this
test on systems using a country protocol other than 1.
1117 ABORT A service state audit message is outstanding.
1. Wait 2 minutes and then try again.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1113 FAIL The signaling link has failed; the system cannot send any messages on behalf
of this trunk.
1. Consult procedures for ISDN-SGR (ISDN-PRI Signaling Group) and
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS Wait 4 minutes and then check the Error Log for any new errors of type 3073. If
there are none, then both sides of the ISDN connection agree on the service
state; the negotiation succeeded. If there is a new 3073 error, then the
negotiation failed (the far-end switch twice failed to respond within 2 minutes).
The switch will automatically retry every 15 minutes. If the trunk was initially in
service, it is now placed in the maintenance/far-end state. Incoming calls will
be accepted, but no outgoing calls can be originated. If an incoming call is
presented, another Service State Audit will be immediately performed in an
attempt to put the DS1 ISDN Trunk in the proper state.
8-1004 Issue 1 May 2002
ISDN-LNK (ISDN Signaling Link Port).
Continued on next page
555-233-143