Avaya S8700 Maintenance Manual page 1560

Maintenance-Object Repair Procedures
Table 8-325. Test #238 Expansion Interface Fiber Out-of-Frame Query Test
— Continued
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test request was not received within the allowable time period.
1. Run the test board UUCSS test separately for each EI endpoint on this
2100 ABORT System resources required to run this test are not available.
1. Run the test board UUCSS test separately for each EI endpoint on this
2500 ABORT Internal system error
1. Run the test board UUCSS test separately for each EI endpoint on this
FAIL EI circuit pack can't frame up to incoming signal. Several fail codes may be
returned depending on which endpoint can't frame up. Error codes 2326,
2327, and 2328 denote Endpoint 1, Endpoint 2, and both endpoints,
respectively.
1. Clear any SYNC and TDM-CLK errors listed in the error log.
2. Run the test board UUCSS test for each EI board on this fiber link and
3. If the EI circuit pack fails Test #238 and is in the PN, and the red LEDs are
4. Enter display errors and follow the associated repair procedures for any
5. Perform the
6. If the test continues to abort, follow normal escalation procedures.
PASS The EI circuit pack(s) have detected the valid framing signal on the fiber.
1. Refer to errors from other EI circuit packs, SNI (SNI) tests, or DS1
8-838 Issue 1 May 2002
fiber link and follow the procedures in
Circuit Pack)''.
fiber link and follow the procedures in
Circuit Pack)''.
fiber link and follow the procedures in
Circuit Pack)''.
follow the appropriate repair sequence for any failing tests.
ON for a large number of circuit packs, then reseat any Tone-Clock circuit
packs in the PN. See the "How to replace Tone-Clock circuit packs"
section of ''TDM-CLK (TDM Bus Clock)'' on page 8-1604
documentation.
SNC-BD (if applicable to this fiber link configuration) or TDM-BUS errors.
''Fault Isolation for Fiber Links'' on page
Chapter 5.
Converter tests (if present) if the link is still not functioning.
''EXP-INTF (Expansion Interface
''EXP-INTF (Expansion Interface
''EXP-INTF (Expansion Interface
Maintenance
4-19", described in
Continued on next page
555-233-143