Avaya S8700 Maintenance Manual page 1640

Maintenance-Object Repair Procedures
Table 8-354. Test #59 Hybrid Line Remote Digital Loop-Around Test — Continued
Error Test
Code Result Description / Recommendation
1, 2, 3 FAIL No response was received within the allowable time period on one of the
transmissions to the terminal. This indicates a problem with the data link to the
voice terminal. This could be a sleeping set problem or it may be due to wiring
or an unplugged or defective set.
1. Check for errors in the error log, for example, error 1537.
2. Remotely issue the busyout and release busy commands, and run the
3. Check the wiring to the set if it appears that the terminal is not responding
4. If the test still fails, replace the circuit pack and reconnect the original
PASS Hybrid Line Remote Digital Looparound test passed. The hybrid circuit pack is
sending and receiving proper messages to and from the voice terminal.
1. If problems still exist, investigate using other circuit pack tests and by
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use the list
2. If the board was found to be correctly inserted in step 1, issue the busyout
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should re-establish the linkage
8-918 Issue 1 May 2002
short test sequence on the port to check for other errors associated with
the port or terminal.
to any tests; otherwise, replace the terminal and rerun the test.
terminal.
examining the station, wiring, and connections.
config command, and resolve any problems that are found.
board command.
between the internal ID and the port. If this is not the case, dispatch to
check to ensure that there is a valid board inserted.
Continued on next page
555-233-143