Avaya S8700 Maintenance Manual page 1158

Maintenance-Object Repair Procedures
Three trunk service states are specified by DS1 CO trunk maintenance:
out-of-service
in-service
disconnect (ready-for-service)
Error Log Entries and Test to Clear Values
Table 8-178. DS1 CO Trunk Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1(a) 57408
1(a) 57487
15(b) Any Port Audit and
Update test (#36)
18(c) 0 busyout trunk
grp/mbr
130(d) None
257(e) 57392 DS1 CO Dial Tone
Seizure test (#314)
513(f) 57393 DS1 CO Dial Tone
Seizure test (#314)
769(g) 57484
1025 DS1 CO Dial Tone
Seizure test (#314)
1281 Conference Circuit
test (#7)
1537 NPE Crosstalk test
(#6)
1793(h)
2562(i)) 16665
2817(j) 52992
3840(k) Port Audit and
Update test (#36)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
2. This alarm will only be raised when the System-Parameter Country form has the Base Tone Generator field set
to 4 (Italy). This alarm will be a MINOR alarm unless 75% or more trunks in this trunk group are out of service,
then the alarm will be upgraded to a MAJOR alarm.
3. Major alarms MO may be downgraded to Warning alarms based on the value used in the set options command.
8-436 Issue 1 May 2002
The trunk is in a deactivated state and cannot be used for either incoming
or outgoing calls.
The trunk is in an activated state and can be used for both incoming and
outgoing calls.
The trunk is in an activated state but can only be used for an incoming call.
Alarm
Level
Any
WARNING
WARNING
MINOR
2
WARNING
MINOR
2
WARNING
MINOR
3
WARNING
MINOR
3
WARNING
MINOR
3
WARNING
On/Off
Board Test to Clear Value
Any test trunk grp/mbr
OFF release trunk grp/mbr
ON test trunk grp/mbr
OFF
OFF
OFF test trunk grp/mbr r 2
ON test trunk grp/mbr l r 4
ON test trunk grp/mbr l r 3
test board UUCSS l
555-233-143