Avaya S8700 Maintenance Manual page 798

Maintenance-Object Repair Procedures
Table 8-31. Test #48 Station Present Test — Continued
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The terminal equipment is not connected to the circuit pack. Some terminal
equipment, such as modems, may fail even when connected properly.
1. Remotely test the equipment.
2. If the test fails again, look for RING-GEN errors in the error log. If present,
3. Check all of the wiring between the station equipment and the switch.
4. If the test still fails, the set may be defective. Check the set, and replace it,
5. Some terminal equipment could fail even when it is connected properly. If
PASS The station is connected properly to the switch. This test may also pass if no
terminal equipment is connected and the terminal is located very far from the
switch. Investigate user-reported troubles on this port by using other port tests
or by examining the station and its wiring.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board's translations are correct. Use the list config
2. If the board was found to be correctly inserted in step 1, issue the busyout
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command.
8-76 Issue 1 May 2002
see ''RING-GEN''.
Refer to ''LA85 Port Tester''
tester. Then, run the test again.
if necessary.
this is the case, disable the test using the change station extension
command (enter n into the
Tests 6, 7, 161, and 35 on this port.
command, and resolve any problems.
board command.
This should re-establish the linkage between the internal ID and the port. If
not, verify that a valid board is inserted.
in Chapter 4 for instructions on using the port
Test field). Note that this action also disables
Continued on next page
555-233-143