Avaya S8700 Maintenance Manual page 1016

Maintenance-Object Repair Procedures
Figure 8-5 on page 8-217
2-part test, substituting "CES mode" for "PNC mode."
Table 8-129. ATM Board Framer Loop-Around Test (#1260)
Error Test
Code Result Description / Recommendation
1002 ABORT Time slots could not be allocated. Traffic could be heavy or time slots could be
out-of-service.
1. Run display errors, and perform repairs associated with TDM-BUS errors.
2. Retry the command up to 3 times at 1-minute intervals.
1003 ABORT Tone receiver could not be allocated.
1. Run display errors, and perform the repairs associated with TTR-LEV and
2. Retry the command up to 3 times at 1-minute intervals.
1015 ABORT ATM-TRK circuit pack not busied out
1. Busyout the ATM circuit pack.
2. Rerun the command.
1033 ABORT ATM-TRK circuit pack not found
1. See if the switch can see the circuit pack. Run status trunk group.
2. Retry the command.
1139 ABORT Major alarm on the EPN's packet bus
1. Run display alarms, and perform the repairs associated with PKT-BUS
2. Run display errors, and perform the repairs associated with PKT-BUS
3. Retry the command.
1141 ABORT Packet-interface circuit pack out of service
1. See
1394 ABORT ATM-TRK circuit pack out of service
1. Run the ATM Board Reset test (#1256).
2000 ABORT Request timed out.
1. Retry the command up to 3 times at 1-minute intervals.
2060 ABORT Packet-bus link has failed.
1. Retry the command up to 3 times at 1-minute intervals.
2. If the test continues to abort, run display errors, and perform the repairs
8-294 Issue 1 May 2002
and Figure 8-6 on page 8-218
TONE-PT errors.
The test cannot run unless there is at least one Tone Detector available in
the EPN that holds the ATM-TRK circuit pack.
errors.
errors.
''PKT-INT (Packet Interface)''.
associated with PKT-INT errors.
show a diagrams of this
Continued on next page
555-233-143