Avaya S8700 Maintenance Manual page 1227

DID-DS1 (Direct Inward Dial Trunk)
Error Log Entries and Test to Clear Values
Table 8-204. DID-DS1 Trunk Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (a) Any
15 (b) Any Port Audit and Update
test (#36)
18 (c)
130 (d) None
257 (e) 57474
57473
513 (f) 57392
769 (g) 57393
1281 Conference Circuit test
(#7)
1537 NPE Crosstalk test
(#6)
1793 (h)
2305 (i) 50944 None
3840 (j) Port Audit and Update
test (#36)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
2. This alarm will only be raised when the System-Parameter Country form has the Base Tone Generator field
set to 4 (Italy). This alarm will be a MINOR alarm unless 75% or more trunks in this trunk group are out of service,
then the alarm will be upgraded to a MAJOR alarm.
3. Major alarms may be downgraded to Warning alarms based on the value used in the set options command.
Notes:
a. Error Type 1—DS1 Interface circuit pack detects a hardware error on the
DS1 DID trunk. The Aux Data field indicates the following:
555-233-143
Alarm
Level
Any
WARNING
WARNING
MAJOR
MINOR
MAJOR
MINOR
MINOR
WARNING
MINOR
WARNING
MAJOR
MINOR
57476 On-hook before wink
57477 On-hook before ready to receive digits
57485 Wink too short for valid signal
On/Off
Board Test to Clear Value
Any test trunk grp#/mbr#
OFF release trunk grp#/mbr#
ON test trunk grp#/mbr#
2
2
ON test trunk grp#/mbr# l r 4
3
ON test trunk grp#/mbr# l r 3
3
test board UUCSS l
OFF
2
Issue 1 May 2002 8-505