Avaya S8700 Maintenance Manual page 836

Maintenance-Object Repair Procedures
Station Present Test (or Ringing Application Test)
(#48)
This test applies momentary ringing voltage to the terminal equipment and
monitors resulting current flow to determine whether terminal equipment is
connected to the port. This test may cause some terminal equipment to ring
briefly during daily maintenance. If this ringing disturbs the customer or the
terminal equipment, you can disable it via the Tests field on the change station
extension form. However, on some software releases, Tests #6, 7, 161, and 35
also are disabled.
Table 8-44. Test #48 Station Present Test
Error Test
Code Result Description / Recommendation
ABORT Necessary system resources could not be allocated to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1000 ABORT System resources are unavailable. The port may be busy with a valid call.
This result is also reported for the system's Music-On-Hold port when it is
off-hook, which it usually is.
1. Enter display port UUCSSpp to determine the station's extension.
2. Enter status station extension to determine the service state of the port.
3. If the port is active, wait until it is idle. Retry the command at 1-minute
4. If the test continues to abort, escalate the problem.
1004 ABORT A valid call seized the port during the test and aborted the test.
1. Use the display port UUCSSpp command to determine the station
2. Use the status station extension command to determine the service
3. If the port is active, wait until it is idle before testing. Retry the command at
4. If the test continues to abort, escalate the problem.
1005 ABORT This test was aborted due to a configuration problem. The test is not applicable
for this type of analog port. This error can be ignored.
8-114 Issue 1 May 2002
intervals up to 5 times.
extension.
state of the port.
1-minute intervals up to 5 times.
Continued on next page
555-233-143